|
CP Standardized Centrifugal Pump Range General Product Description
PERFORMANCE RANGE
Flow rate up to 250 l/min (15 m³/hr)
Dynamic head up to 57m
PUMP INSTALLATION AND APPLICATIONS
These pumps are suitable for use with clean water and liquids which are not chemically aggressive
to the pump components.
SPECIFICALLY INTENDED FOR USE IN THE CIVIL, INDUSTRIAL AND AGRICULTURAL SECTORS WHERE THEIR OVERRIDING CHARACTERISTICS OF STURDINESS AND RELIABILITY ARE BEST APPRECIATED.
Built according to EN 733 - DIN 24255, these pumps have standard
overall dimensions, sizes and positioning of the delivery and suction
ports, support base and other dimensions. This means that the pumps
chosen will be adequately designed to handle heavy-duty operation
and can be interchanged with other standardized pumps.
These pumps should be installed in a covered area, protected
against the weather.
PERFORMANCE
A wide range of pumps make up the standardized CP series,
enabling the most suitable model for a particular application to
be chosen. This means high performance, coupled with reduced running
costs, particularly important for powerful machines, often intended
for continuous use. When developing individual models care was taken
to aim at standardizing the following features within the series.
- Long flat performance curves;
- flat absorption curves at high delivery rates, preventing
motor overloading even during prolonged use;
- good suction capacities both at low and high delivery rates
Curve tolerance according to ISO 2548
STRUCTURAL CHARACTERISTICS
- Cast iron Pump Body, built according to EN 733 - DIN 24255
and UNI 7467 - NF E-44-111 with UNI ISO 228/1 gas threaded suction
and delivery ports
- BRASS IMPELLER, centrifugal radial flow type.
- Stainless steel MOTOR SHAFT AISI 316
- Motor: pumps are coupled directly to an asynchronous,
high efficiency PEDROLLO induction motor, which is quiet
running, closed and externally ventilated, with <IM B3>
structural shape, suitable for continuous duty. INSULATION
class F (B up to 0.75 kW)
A thermal cutout device (motor protector) is incorporated
in single phase motors up to 1.5kW
NOTE: Other single phase and all three phase motors require an adequate external motor protector
complying with current standards
- PROTECTION IP 44
- CONSTRUCTION AND SAFETY STANDARDS
complies with EN 60 335 -1, CEI 61-150, EN60034-1, IEC
34-1, CEI 2-3
- REGISTERED MODEL
*Installations must comply to Water Bye-laws in the UK.
PERFORMANCE CURVE
PERFORMANCE DATA
PRODUCT DIMENSIONS
Buy the CP25 Centrifugal Pump Online >>
|
