Twin 4CR with SteadyPres Invertor Set Ref: P/4CR/STEADY
For top performance and control, combine the stainless steel three phase 4CR80 pump with the NEW STEADYPRES ENERGY SAVING variable speed pump controller. These units are well suited to very large domestic premises or small commercial properties with lots of outlets (showers, taps etc) and a wide variation in water requirements. The units come pre-assembled on a base-plate with stainless steel inlet/outlet manifolds. They are pre-wired ready to go and work on a duty/assist basis (second pump comes on when water demand increases). This twin pump-set is capable of up to 100 litres/min @ about 3 bar.
Manifold sizes: 1 ½"
NB All pumps must be fed from a suitably sized water tank. STEADYPRES is an electronic device based on INVERTER TECHNOLOGY that maintains constant system pressure by regulating the starting and speed of the pump. Mains voltage (230V) is required to power the pump-set. STEADYPRES FEATURES: Adjustable pressure set-point , i.e. pressure value which will be held constant subject to the capability of the pumpAdjustable start pressureProtection from dry running in case of water supply failure Automatic reset following shutdown caused by dry running, The restart parameters can also be adjustedAlphanumeric backlit display with real time indication of the system pressure and of the pump motor speedMaximum environment temperature 40 degrees C. Max liquid temperature 50°CIntegrated pressure sensor and heat dissipatorLED Indicators Fully in compliance with the EMC directiveFor correct installation and operation of the twin STEADYPRES pump-set, a 24 litre pressure vessel is required and is included in the price shown
Click here to see a 360° image of this pump
Price : £2,154.00 (Including VAT at 20%)
| 
